πŸ”₯ Pro Boat Blackjack inch Catamaran Brushless RC Boat: Ready-To-Run | Horizon Hobby

Most Liked Casino Bonuses in the last 7 days πŸ€‘

Filter:
Sort:
JK644W564
Bonus:
Free Spins
Players:
All
WR:
60 xB
Max cash out:
$ 500

So 3s Lipo who wants to guess the top speed? Water was slightly choppy and slightly breezy. The boat did a consistent 25mph one of these.


Enjoy!
Valid for casinos
Visits
Likes
Dislikes
Comments
blackjack 24 top speed

🎰

Software - MORE
JK644W564
Bonus:
Free Spins
Players:
All
WR:
60 xB
Max cash out:
$ 500

My first impression of the Blackjack 24 was that this smaller boat will not come close to Under the plastic cover on top of the transmitter is the on/ off switch, battery level This is a common design for boats built for speed.


Enjoy!
Valid for casinos
Visits
Likes
Dislikes
Comments
blackjack 24 top speed

🎰

Software - MORE
JK644W564
Bonus:
Free Spins
Players:
All
WR:
60 xB
Max cash out:
$ 500

Pro Boat Blackjack inch Catamaran Brushless: RTR RC BoatCapable of reaching speeds of 30 MPH with optional accessories | Equipped with a brushless.


Enjoy!
Valid for casinos
Visits
Likes
Dislikes
Comments
blackjack 24 top speed

🎰

Software - MORE
JK644W564
Bonus:
Free Spins
Players:
All
WR:
60 xB
Max cash out:
$ 500

Equipped with a brushless Kv water-cooled motor and 30A Li-Po compatible ESC.


Enjoy!
Valid for casinos
Visits
Likes
Dislikes
Comments
blackjack 24 top speed

🎰

Software - MORE
JK644W564
Bonus:
Free Spins
Players:
All
WR:
60 xB
Max cash out:
$ 500

list.kangarooperm.ru β€Ί watch.


Enjoy!
Valid for casinos
Visits
Likes
Dislikes
Comments
blackjack 24 top speed

🎰

Software - MORE
JK644W564
Bonus:
Free Spins
Players:
All
WR:
60 xB
Max cash out:
$ 500

Equipped with a brushless Kv water-cooled motor and 30A Li-Po compatible ESC.


Enjoy!
Valid for casinos
Visits
Likes
Dislikes
Comments
blackjack 24 top speed

🎰

Software - MORE
JK644W564
Bonus:
Free Spins
Players:
All
WR:
60 xB
Max cash out:
$ 500

Capable of reaching speeds of 30 MPH with optional accessories; Equipped with a RTR ProBoat Blackjack 24 Catamaran with Motor, ESC, Radio Android phone inside with a gps speedometer app and it recorded a top speed of 33 mph.


Enjoy!
Valid for casinos
Visits
Likes
Dislikes
Comments
blackjack 24 top speed

🎰

Software - MORE
JK644W564
Bonus:
Free Spins
Players:
All
WR:
60 xB
Max cash out:
$ 500

Off-set rudder system provides superb stability and keeps the.


Enjoy!
Valid for casinos
Visits
Likes
Dislikes
Comments
blackjack 24 top speed

🎰

Software - MORE
JK644W564
Bonus:
Free Spins
Players:
All
WR:
60 xB
Max cash out:
$ 500

Pro Boat Blackjack inch Catamaran Brushless: RTR RC BoatCapable of reaching speeds of 30 MPH with optional accessories | Equipped with a brushless.


Enjoy!
Valid for casinos
Visits
Likes
Dislikes
Comments
blackjack 24 top speed

🎰

Software - MORE
JK644W564
Bonus:
Free Spins
Players:
All
WR:
60 xB
Max cash out:
$ 500

Pro Boat Blackjack inch Catamaran Brushless: RTR RC BoatCapable of reaching speeds of 30 MPH with optional accessories | Equipped with a brushless.


Enjoy!
Valid for casinos
Visits
Likes
Dislikes
Comments
blackjack 24 top speed

Join Date Oct Location la Posts 8, The gap you have in the last pic between the drive dog and strut is WAY to tight. When I tore things down after the next outing, I noticed increased slop in the drive line at the strut. Originally Posted by kfxguy. Looks like I need to grind myself a custom tool to get the old ones out, or I might just drill them out with a dremel. Next trip to the pond, there was a noticeable improvement in output from the side of the hull. Between the first few runs and a lot of threads I've read online, the typical Proboat shortcomings have played out and I'm taking care of them with aftermarket parts as needed. I did a little file work on the rudder trying to eliminate the flat bottom surface while my last battery was charging. Originally Posted by fweasel. My family is out of town visiting family, so I headed out to the lake after work tonight. Should be faster and hopefully run a whole lot cooler. I didn't get as much material removed as I had hoped, so I plan to take the rudder off and put it on the grinder later this week. You are currently viewing our forum as a "guest".

Please take a moment to read this. That's when I found Kintect Racing. OSE is a tight knit community of like minded rc boating enthusiasts blackjack 24 top speed value "on topic" and clean discussions.

I should get my stainless prop back from dasboata next week, interested to see if there's a bump in speed over the plastic version with the same size and pitch.

I ordered a new strut and flex shaft from Kintec to fix the worn stuffing tube blackjack 24 top speed ridiculous side to side slop. All rights reserved.

Think I need to add a 9mm wrench to the tool box because the new coupler is slightly smaller than the original, which used 2 10mm wrenches. I have no data, but I assume it was a slower run with the prop running deeper in the water. Still trying to get the old hatch screws out of the deck so I can install this set of spring loaded pins. It was a forest preserve pond cricket creek, Villa Park designated for RC boat usage, water was like glass. My Proboat Blackjack 24 project progress I recently got back into the RC boat hobby after discovering how far things had progressed with lipo batteries and brushless motors. You can tell its going to hold the flex shaft and not crack into two pieces! No speed was recorded today, forgot the GPS at home. After I installed the new strut, it was set-up pretty low. If you have any problems with the registration process or your account login, please contact us by clicking here. I think I'm going to plumb a second water pick-up at the bottom of a sponson to cool the motor and ESC separately. I have so much more confidence every time I tighten up the coupler. I also shimmed the rudder push rod at the servo horn with a home made plastic washer and a little super glue. Shortly after the first run, I drilled out the cooling pick-up on the rear rudder. I think I'll eventually install an additional pick-up on the bottom of the hull and cool the ESC and motor separately. The new prop gave the boat a little extra speed and the motor and battery only appeared slightly warmer to the touch after a full run. A guest will not be able to post questions or view pictures and videos. Drill in at the same angle as the original and don't go too deep or you'll drill through the back of the rudder. The previous weekend the boat run much flatter with no bounce, this was with the strut much lower. Results 1 to 14 of Thread: My Proboat Blackjack 24 project progress. Got the GPS installed today, but forgot to start it for the first battery. I ordered two new stock flex shafts didn't know about the upgraded options yet and a PRB 1. Your pic looks like you can see through the hole. Archive Top. Please click here to Join now. You're right, it wasn't adjusted properly there. Great deals from Craigslist and Amazon on these two new additions to the tackle box Forerunner Wish I lived in the suburbs with a retention pond in my back yard that I could walk to in 30seconds. I installed the same Kintec Racing motor mount and coupler in the Shockwave that I put in the Blackjack. It always seemed crazy that there was never any type of bearing or even a bushing back there and that this kind of wear was inevitable. Next trip out, lost the flex shaft and prop 10 seconds into the run. Bookmarks Bookmarks Google. By joining our free community you will have access to post topics, create your own image gallery to share with everyone, communicate privately with other members PM , respond to polls, upload content and access many other special features. Attached Images strut. Downtown living is tough on this hobby and driving to useful bodies of water. Registration is fast, simple and absolutely free. Figured I was staying ahead of the game. Thread Tools Show Printable Version. Second battery I remembered to start it and I got a max speed of Aside from cooling, the only setup change I plan on making before my next run will be to finish the rudder reshape. I'll drill out the cooling pick-up, grease the flex shaft, and run a 3S battery through it before I start modifying anything else. Doesn't the washer help? I brought it in after a few laps to check the temps and added a little negative trim to the prop. Originally Posted by LuckY So you didn't actually drill through the rudder? My son and I tried out a new spot I found online. I found the drill bit the same size as the hole on the side of the rudder, then got the next larger bit and redrilled the hole to open it up. The rest of the run was the same as the first and the trim adjustment didn't seem to change the bounce. Sunday was a good day at the pond. I also just picked up a used Shockwave 26 V3 on eBay. The Blackjack ran much drier after raising the strut, but has some bounce flat out in the straights. All times are GMT The time now is PM. I made no other set-up changes for today's runs, just trying to get some more temperature and speed data. This weeks modifications were mostly Shockwave related. I had used a collar style attachment on my old nitro tunnel hull rudder, but my box of spare parts are long gone so I worked with what I had. That firmed things up and took a fair amount of slop out of the rudder. Hopefully the water is smooth and I can get a good sense of the trim angle.